- Notes, cautions, and warnings
- Working on your computer
- Docking Your Computer
- Disassembly
and reassembly
- Recommended Tools
- Screw size list
- System Overview
- Removing the Battery
- Installing the Battery
- Removing the Base Cover
- Installing the Base Cover
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the mSATA SSD
- Installing the mSATA SSD
- Removing the memory module
- Installing the memory module
- Removing the WWAN Card
- Installing the WWAN Card
- Removing the WLAN Card
- Installing the WLAN Card
- Removing the System Fan
- Installing the System Fan
- Removing the Display Bezel
- Installing the Display Bezel
- Removing the Display Panel
- Installing the Display Panel
- Removing the Camera
- Installing the Camera
- Removing the Keyboard Trim
- Installing the Keyboard Trim
- Removing the Keyboard
- Installing the Keyboard
- Removing the Palmrest
- Installing the Palmrest
- Removing the Speakers
- Installing the Speaker
- Removing the I-O Board
- Installing the I-O Board
- Removing the Display-Hinge Cover
- Installing the Display-Hinge Cover
- Removing the Display Assembly
- Installing the Display Assembly
- Removing the System Board
- Installing the System Board
- Removing the Heatsink
- Installing the Heatsink
- Removing the Power-Connector Port
- Installing the Power Connector
- System Setup
- Diagnostics
- Specifications
- Contacting Dell EMC
Dell Latitude E7450 Owner's Manual
Installing the I-O Board
- Insert the I/O board to its place on the computer.
- Tighten the screws to secure the I/O board to the computer.
- Connect the I/O board cable to its connector on the system board.
- Install:
- Follow the procedures in After Working Inside Your computer .
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\