Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell Latitude 12 Rugged Extreme — 7204Series Owner's Manual

PDF

Installing the Display Assembly

  1. Install the display assembly and close the display.
  2. Flip the computer chassis.
  3. Install the display hinges in their slots.
  4. Tighten the screws to secure the hinges.
  5. Route the cables through the rubber gasket.
  6. Install the hinge cover.
  7. Tighten the screws to secure the hinge cover.
  8. Install the eDP connector and place the bracket in its slot.
  9. Tighten the screws to secure the eDP connector to the system board.
  10. Route the cable through the routing channels.
  11. Install:
    1. heatsink

    2. WWAN

    3. WLAN

    4. card bracket

    5. Connect the battery cable to battery board.
    6. hard drive

    7. MEMS board

    8. USH board

    9. GPS module

    10. docking board

    11. bottom cover

    12. battery

  12. Follow the procedures in After Working Inside Your computer .

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\