Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Latitude 5430 Service Manual

Installing the M.2 2280 solid-state drive

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the M.2 2280 solid-state drive and provides a visual representation of the installation procedure.

Installing the M.2 2280 solid-state drive

Steps

  1. Align the notch on the M.2 2280 solid-state drive with the tab on the solid-state drive slot.
  2. Slide the M.2 2280 solid-state drive into the solid-state drive slot on the system board.
  3. Align the screw holes on the M.2 2280 solid-state drive thermal plate with the screw holes on the system board.
  4. Replace the two (M2x3) screws to secure the M.2 2280 solid-state drive thermal plate to the system board.

Next steps

  1. Install the base cover.
  2. Install the microSIM card.
  3. Install the microSD card.
  4. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\