- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Latitude 5430
- SIM card tray
- MicroSD card
- Base cover
- WLAN card
- Wireless Wide Area Network (WWAN) card
- Solid-state drive
- Memory module
- Battery
- Battery cable
- Assembly-inner frame
- LED board
- Heat sink
- Speakers
- System board
- Power-button board
- Smart card reader
- Keyboard assembly
- Display assembly
- Display bezel
- Display panel
- Camera/microphone module
- eDP/display cable
- Sensor board
- Display hinges
- Display back cover
- Palm-rest assembly
- Dummy SIM-card slot filler
- Drivers and downloads
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Auto RTC reset
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 5430 Service Manual
Removing the eDP cable
Prerequisites
- Follow the procedure in before working inside your computer.
- Remove the microSD card.
- Remove the microSIM card.
- Remove the base cover.
- Remove the WLAN card.
- Remove the WWAN card.
- Remove the display assembly.
- Remove the display bezel.
- Remove the display panel.
About this task
The following images indicate the location of the eDP cable and provide a visual representation of the removal procedure.
Steps
- Disconnect the eDP cable from the connector on the camera/microphone module.
- Peel the conductive tape and unroute the eDP cable to release it from adhesive and lift the eDP cable from the display back cover.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\