- Notes, Cautions, and Warnings
- Working on Your Computer
- Removing and
Installing Components
- Recommended Tools
- Removing the Base Cover
- Installing the Base Cover
- Removing the Battery
- Installing the Battery
- Removing the Hard Drive
- Installing the Hard Drive
- Removing the WLAN Card
- Installing the WLAN Card
- Removing the System Fan
- Installing the System Fan
- Removing the Keyboard
- Installing the Keyboard
- Removing the Base Frame
- Installing the Base Frame
- Removing the Heatsink
- Installing the Heatsink
- Removing the I/O Board
- Installing the I/O Board
- Removing the Coin-Cell Battery
- Installing the Coin-Cell Battery
- Removing the Display Assembly
- Installing the Display Assembly
- Removing the Display Bezel
- Installing the Display Bezel
- Removing the Display Panel
- Installing the Display panel
- Removing the Display Hinge
- Installing the Display Hinge
- Removing the Camera
- Installing the Camera
- Removing the System Board
- Installing the System Board
- Removing the Speakers
- Installing the Speakers
- Removing the Power Connector
- Installing the Power Connector
- System Setup
- Diagnostics
- Specifications
- Contacting Dell
Dell Latitude 3450 Owner's Manual
Installing the System Fan
- Place the system fan on its slots in the computer.
- Tighten the screw to secure the system fan to the computer.
- Route the cable to the slot.
- Connect the fan cable to the computer.
- Affix the I/O board cable.
- Press the locking tab.
- Install
- Follow the procedures in After Working Inside Your computer .
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\