Latitude 9510 Service Manual

Installing the solid-state drive

If you are replacing a component, remove the existing component before performing the installation procedure.

The following image indicates the location of the solid-state drive and provides a visual representation of the installation procedure.

Align the notch on the solid-state drive with the tab on the M.2 card slot.
Slide the solid-state drive into the M.2 card slot on the system board.
Replace the screw (M2x2) that secures the solid-state drive to the system board.
Align and place the solid-state drive shield, press to fit it firmly to cover the solid-state drive.

Install the Base cover.
Install the SIM card tray.
Install the microSD card.
Follow the procedure in After working inside your computer.
Verify if the storage device is installed correctly:
1. Turn on or restart your computer.
2. Press F2 when the Dell logo is displayed on the screen to enter the system setup (BIOS) program.
  NOTE: A list of storage devices are displayed under the System Information in the General group.
3. If you have replaced the primary storage device that had the operating system installed, see Reinstall Windows 10 to the Dell factory image using recovery media in the knowledge base article 000176966.