Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Latitude 9510 Service Manual

Removing the 4-cell battery

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the microSD card.
  3. Remove the SIM card tray.
  4. Remove the Base cover.
  5. Remove the Speakers.
NOTE: If battery was disconnected from system board for service, there will be a delay during system boot-up as the system will undergo RTC battery reset.

About this task

The following images indicate the location of the battery and provide a visual representation of the removal procedure.

Removing the 4-cell battery

Steps

  1. Peel off the adhesive tape securing the wireless antenna cables in place and unroute the wireless antenna cables from the routing guides.
    NOTE: The cables for the wireless antennas are routed over the plastic bracket at the upper left corner and within the routing channels along the left and bottom side of the battery. Technicians must be careful when unrouting the antenna cables from their routing guides while they are still attached to the wireless card.
  2. Remove the single (M1.6x3.5) screw and four (M2x3) screws that secures the battery.
  3. Lift the battery from the left side of the system, and remove the battery from the laptop.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\