Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Latitude 7530 Service Manual

PDF

Removing the palm-rest assembly

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the microSIM-card tray.
  3. Remove the base cover.
  4. Remove the M.2 2230 solid-state drive or the M.2 2280 solid-state drive, whichever applicable.
  5. Remove the WWAN card, if applicable.
    NOTE This procedure applies only to computers shipped with a WWAN card installed.
  6. Remove the 3-cell battery or the 4-cell battery, whichever applicable.
  7. Remove the heat-sink.
  8. Remove the WLAN-antenna and tweeter-speakers module, if applicable.
    NOTE This procedure applies only to computers shipped with a WLAN-antenna module installed on the palm-rest and keyboard assembly.
  9. Remove the display assembly.
  10. Remove the audio daughter-board.
  11. Remove the main-speakers daughter-board.
  12. Remove the main-speakers.
  13. Remove the tweeter speakers, if applicable.
    NOTE This procedure applies only to computers shipped with a WLAN-antenna module installed in the display assembly.
  14. Remove the system board.
  15. Remove the I/O daughter-board.
  16. Remove the power button with optional fingerprint reader.
  17. Remove the keyboard.

About this task

NOTE The palm-rest assembly cannot be further disassembled once all the pre-removal parts procedures are completed. If the keyboard is malfunctioning and is required to be replaced, replace the entire palm-rest assembly.

The image below shows the palm-rest assembly after the pre-removal parts procedures have been performed for any palm-rest assembly replacement.

Image of palm-rest and keyboard assembly

Steps

  1. For computers shipped with a carbon fiber palm-rest, use a fine-tipped instrument to push the microSIM filler outwards to remove it from its slot on the palm-rest assembly.
    NOTE The microSIM filler must be transferred to the new replacement palm-rest assembly.
  2. After performing the pre-requisites, you are left with the palm-rest assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\