Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Latitude 7520 Service Manual

Removing the tweeters and palmrest antenna assembly

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the microSD card.
  3. Enter the service mode.
  4. Remove the base cover.
  5. Remove the heatsink assembly.

About this task

The following images indicate the location of the tweeters and palmrest antenna assembly and provide a visual representation of the removal procedure.

Disconnect WLAN and tweeter cable and unroute them.

Remove the tweeter and WLAN antenna.

Steps

  1. Remove the single (M2x2) screw securing the WLAN card bracket to the antenna cables and remove the bracket from the computer.
  2. Disconnect the WLAN antenna cables from the WLAN module and unroute the cable from the guides on the system board.
  3. Remove the two (M2x2) screws securing the display cable bracket to the system board and disconnect the display cable.
  4. Disconnect the camera, touch screen, sensor board cables from the system board and unroute them from the guiding tabs on the tweeters.
  5. Disconnect the tweeter cable from the audio board.
  6. Peel back the mylar tape securing the tweeter cable to the keyboard bracket.
  7. Peel the tape securing the tweeter cable to the audio board FFC and I/O board.
  8. Pry and remove the tweeters or with palmrest antenna assembly from the computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\