- Notes, cautions, and warnings
- Working on your computer
- Removing and installing components
- Recommended tools
- Screw List
- Major components of your system
- micro-SD card
- SIM card tray
- Base cover
- Solid-state drive
- WWAN card
- Battery
- Heatsink assembly
- Speaker board
- Display assembly
- Speakers
- Tweeters
- Tweeters and palmrest antenna assembly
- Smart card reader
- Audio board
- System board
- I/O board
- Power button with fingerprint reader
- Keyboard
- Palmrest assembly
- Software
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 7520 Service Manual
Removing the power button with fingerprint reader
Prerequisites
- Follow the procedure in before working inside your computer.
- Enter the service mode.
- Remove the microSD card.
- Remove the SIM card.
- Remove the base cover.
- Remove the solid-state drive.
- Remove the heatsink assembly.
- Remove the system board.
About this task
The following images indicate the location of the power button with fingerprint reader and provide a visual representation of the removal procedure.
Steps
- Remove the two (M1.6x1.7) screws securing the power button with fingerprint reader to the computer.
- Lift and remove the power button with fingerprint reader from the computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\