- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Latitude 7430
- microSIM-card tray
- Base cover
- M.2 solid-state drive (for clamshell computers)
- Removing the M.2 2230 solid-state drive (for computers shipped without a thermal plate)
- Installing the M.2 2230 solid-state drive (for computers shipped without a thermal plate)
- Removing the M.2 2230 solid-state drive (for computers shipped with a thermal plate)
- Installing the M.2 2230 solid-state drive (for computers shipped with a thermal plate)
- Removing the M.2 2280 solid-state drive
- Installing the M.2 2280 solid-state drive
- M.2 solid-state drive (for 2-in-1 computers)
- WWAN card
- Battery
- Heat-sink
- WLAN-antenna module
- Coin-cell battery
- Display assembly
- Audio daughter-board
- Speakers
- Smart card reader
- System board
- I/O daughter-board
- Power button with optional fingerprint reader
- Keyboard
- Palm-rest assembly
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 7430/Latitude 7430 2-in-1 Service Manual
Installing the 3-cell battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the 3-cell battery and provides a visual representation of the installation procedure.
Steps
- Carefully push the battery filler upwards to attach it to the 3-cell battery.
- Place the 3-cell battery along with the battery cable on the palm-rest and keyboard assembly.
- Align the screw holes on the 3-cell battery to the screw holes on the palm-rest and keyboard assembly.
- Tighten the three captive screws to secure the 3-cell battery to the palm-rest and keyboard assembly.
- Connect the battery cable to the connector on the system board.
Next steps
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\