- Notes, cautions, and warnings
- Working on your computer
- System overview
- Removing and
installing components
- Recommended tools
- Press latch doors
- Stylus and tether
- Battery
- Base cover
- Battery connector
- Hard drive
- Solid State Drive (SSD)
- Handle
- Docking board
- Memory module
- ExpressCard module
- Optical drive
- Graphics Processing Unit (GPU)
- Heat sink
- System fan
- Global Positioning System (GPS)
- USH daughter board
- LED board
- Fingerprint reader
- Subscriber Identity Module(SIM) board
- Coin cell battery
- WLAN card
- WWAN card
- RF cable holder
- GPS holder
- System board
- Smart card module
- Palmrest
- Input/Output(I/O) board
- Keyboard
- Keyboard control board
- Speaker
- Power connector
- Display assembly
- Display panel
- Camera
- Touchscreen controller board
- System Setup
- Diagnostics
- Using your computer
- Technology and components
- Technical specifications
- System information specifications
- Processor specifications
- Memory specifications
- Battery specifications
- Audio specifications
- Video specifications
- Communication specifications
- Port and connector specifications
- Display specifications
- Touchpad specifications
- Keyboard specifications
- Adapter specifications
- Physical dimension specifications
- Environmental specifications
- General troubleshooting
- Contacting Dell
Dell Latitude 14 Rugged Extreme – 7414 Owner's Manual
Installing the docking board
- Connect the docking board connector cable to the system board.
- Align the docking board with the system board and install the screws that secure it.
- Route the docking board antenna cables through the routing channels.
- Connect the antenna cables to the corresponding location on the docking board.
- Install the:
- Follow the procedure in After working inside your computer .
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\