Dell Latitude 14 Rugged Extreme – 7414 Owner's Manual

Before working inside your computer

To avoid damaging your computer, perform the following steps before you begin working inside the computer.

Ensure that you follow the Safety instructions.
Ensure that your work surface is flat and clean to prevent the computer cover from being scratched.
Turn off your computer (see Turning off your computer ).
If the computer is connected to a docking device (docked) such as the optional Media Base or Battery Slice, undock it.
- CAUTION: To disconnect a network cable, first unplug the cable from your computer and then unplug the cable from the network device.
Disconnect all network cables from the computer.
Disconnect your computer and all attached devices from their electrical outlets.
Close the display and turn the computer upside-down on a flat work surface.
- NOTE: To avoid damaging the system board, remove the main battery before you service the computer.
Remove the main battery.
Turn the computer top-side up.
Open the display.
Press the power button to ground the system board.
- CAUTION: Before touching anything inside your computer, ground yourself by touching an unpainted metal surface, such as the metal at the back of the computer. While you work, periodically touch an unpainted metal surface to dissipate static electricity, which could harm internal components.
Remove any installed ExpressCards or Smart Cards from the appropriate slots.