- Notes, cautions, and warnings
- Notes, cautions, and warnings
- Working on your computer
- Technology and components
- Major components of your system
- Disassembly and reassembly
- Troubleshooting
- Getting help
Latitude 7410 Chromebook Service Manual
Installing the system board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the system board and provide a visual representation of the installation procedure.
Steps
- Align and place the system board into the palmrest assembly, and replace the three (M2x2.5) screw securing the system board to the palmrest assembly.
- Place the USB Type-C bracket on to the USB C ports.
- Secure the USB Type-C bracket using the three (M2x5) screws.
- Connect the following cables:
- Battery LED cable
- Touchpad cable
- Connect the speaker cable to the connector on the system board.
- Connect the eDP and camera cable to the connectors on the system board.
- Place the eDP bracket on the display cable and install the two (M2x2) screws securing it to the system board
- Re-route the antennae cable on the system board and reconnect the WWAN antennas.
- Place the WWAN bracket on the antennas and install the single (M2x2.5) screws securing it to the system board.
Next steps
If you are replacing a component, remove the existing component before performing the installation procedure.
- Install the:
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\