- Notes, cautions, and warnings
- Notes, cautions, and warnings
- Working on your computer
- Technology and components
- Major components of your system
- Disassembly and reassembly
- Troubleshooting
- Getting help
Latitude 7410 Chromebook Service Manual
Installing the heatsink assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the heatsink assembly and provide a visual representation of the installation procedure.
Steps
- Place the heatsink assembly into the slot in the system board and replaced the five (M2x2.5) screws to secure it to the system board.
- Reconnect the fan cable to the connector on the system board.
- Place the WLAN bracket onto the WLAN antennas and replace the single (M2x2.5) screw that secures the shield plate to te system board
NOTE The fan cable must be routed under the shield plate.
Next steps
- Reconnect the battery cable.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\