CAUTION:The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the display panel and provide a visual representation of the installation procedure.
Figure 1. Installing the display panel
Steps
Connect the display cable to the connector on the display panel and close the latch to secure the cable.
Adhere the tape that secures the display cable to the display panel.
Connect the G-sensor cable to the connector (JSENTS1) on the G-sensor board (optional).
Rotate the display panel and place it on the display back cover.
NOTE:Ensure that the display panel tabs are inserted into the slots on the display back cover.
Replace the two screws (M2.5x3) that secure the display panel to the display back cover.
