- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Latitude 5430 Rugged
- Battery
- Primary solid state drive
- Passive stylus
- Handle
- Keyboard
- Base cover
- Coin-cell battery
- Fan
- Wi-Fi I/O board
- WLAN card
- Wireless Wide Area Network (WWAN) card
- Dock I/O board
- LED board
- Left I/O board
- Speakers
- Secondary daughterboard
- Heat sink
- Rear I/O board
- System board
- Memory modules
- Right Type-C daughterboard
- Left Type-C daughterboard
- Power-button board
- Power button with fingerprint reader
- Display assembly
- Display bezel
- Camera
- Display hinges
- Display cable
- Display panel
- Display back-cover
- Palmrest assembly
- Drivers and downloads
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Using Non-Latitude 5430 Rugged batteries
- Getting help and contacting Dell
Latitude 5430 Rugged Service Manual
Installing the Wi-Fi I/O board
Prerequisites
About this task
The following image indicates the location of the Wi-Fi I/O board and provides a visual representation of the installation procedure.
Steps
- Place and align the Wi-Fi I/O board with screw holes on the system board.
- Connect the flexible printed cable to the
Wi-Fi I/O board.
Adhere the flexible printed cable with kapton tape to the connector.
- Replace the two (M2.5x5) screws that secure the Wi-Fi I/O board to the system board.
- Connect the WLAN, WWAN, and GPS antennas to the
Wi-Fi I/O board.
Table 1. Cable connectors on Latitude 5430 RuggedThis table provides the cable connections of your system: Cable number Antenna 5 WWAN antenna on Wi-Fi I/O board 1 WWAN antenna on Wi-Fi I/O board 12 WWAN antenna on Wi-Fi I/O board 2 WLAN antenna on Wi-Fi I/O board 13 WLAN antenna on Wi-Fi I/O board 10 WLAN antenna on Wi-Fi I/O board 11 GPS antenna on Wi-Fi I/O board 14 GPS antenna on Wi-Fi I/O board 4 GPS antenna on Wi-Fi I/O board
Next steps
- Install the base cover.
- Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
- Install the battery.
- Follow the procedure in after working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\