Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Latitude 5430 Rugged Service Manual

Removing the display assembly

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the battery.
  3. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
  4. Remove the keyboard.
  5. Remove the base cover.
  6. Remove the Wi-Fi I/O board.
  7. Remove the WLAN card.
  8. Remove the WWAN card.
  9. Remove the dock I/O board.
  10. Remove the rear I/O board.
  11. Remove the fan.
  12. Remove the heat-sink (UMA) or heat-sink (discrete).
  13. Remove the system board.

About this task

The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.

This image displays the removal of the display assembly screws

This image displays the removal of the display assembly

Steps

  1. Remove the two (M3x7, T8) epoxy screws and two (M2.5x5) screws that secure the hinge covers to the system chassis and open the display.
  2. Remove the two (M2.5x7) screws that secure the left/right hinge covers to the system chassis.
  3. Remove the four (M3x7, T8) epoxy screws that secure the display assembly to the system chassis.
  4. Lift and remove the display assembly from the system chassis.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\