Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Latitude 5430 Rugged Service Manual

PDF

Removing the rear I/O board

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the battery.
  3. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
  4. Remove the base cover.

About this task

The following images indicate the location of the rear I/O board and provide a visual representation of the removal procedure.

This image displays the removal of rear I/O board

Steps

  1. Peel the adhesive tape and unroute the cables from the routing channels on the system chassis.
  2. Disconnect the rear I/O flat printed cable and remove the two (M2.5x5) screws that secure the rear I/O board to the system board.
    NOTE:Disconnect the GPS cable and tilt the rear I/O board at an angle to remove it.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\