Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Latitude 5430 Rugged Service Manual

PDF

Installing the rear I/O board

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the rear I/O board and provides a visual representation of the installation procedure.

This image displays the replacing of rear I/O board

Steps

  1. Replace the two (M2.5x5) screws to secure the rear I/O board to the system board and connect the rear I/O flat printed cable.
    Adhere the rear I/O flat printed cable with kapton tapes to the connector.
  2. Route the cables using the routing channels on the system chassis and adhere the adhesive tape on the rear I/O board.

Next steps

  1. Install the base cover.
  2. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
  3. Install the battery.
  4. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\