Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Latitude 5430 Rugged Service Manual

Installing the left Type-C daughterboard

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the left Type-C daughterboard and provides a visual representation of the installation procedure.

This image displays the replacing of left type-c daughterboard

Steps

  1. Place the left Type-C daughterboard on the system chassis.
  2. Replace the four (M2x3.5) screws to secure the left Type-C daughterboard to the system chassis.
  3. Connect the daughterboard cable to its connector on the left Type-C daughterboard.
  4. Connect the flat printed cable to its connector on the left Type-C daughterboard.
  5. Replace the (M2x3.5) screw that secures the flat printed cable holder to the left Type-C daughterboard.

Next steps

  1. Install the system board.
  2. Install the rear I/O board.
  3. Install the dock I/O board.
  4. Install the WWAN card.
  5. Install the WLAN card.
  6. Install the Wi-Fi I/O board.
  7. Install the heat-sink (UMA) or heat-sink (discrete).
  8. Install the fan.
  9. Install the base cover.
  10. Install the keyboard.
  11. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
  12. Install the battery.
  13. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\