- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Latitude 5430 Rugged
- Battery
- Primary solid state drive
- Passive stylus
- Handle
- Keyboard
- Base cover
- Coin-cell battery
- Fan
- Wi-Fi I/O board
- WLAN card
- Wireless Wide Area Network (WWAN) card
- Dock I/O board
- LED board
- Left I/O board
- Speakers
- Secondary daughterboard
- Heat sink
- Rear I/O board
- System board
- Memory modules
- Right Type-C daughterboard
- Left Type-C daughterboard
- Power-button board
- Power button with fingerprint reader
- Display assembly
- Display bezel
- Camera
- Display hinges
- Display cable
- Display panel
- Display back-cover
- Palmrest assembly
- Drivers and downloads
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Using Non-Latitude 5430 Rugged batteries
- Getting help and contacting Dell
Latitude 5430 Rugged Service Manual
Installing the display hinges
Prerequisites
About this task
The following image indicates the location of the display hinges and provides a visual representation of the installation procedure.
Steps
- Align the left hinge and replace the two (M3x7, T8) and (M3x5, T8) epoxy screws to secure the left hinge to the display assembly.
- Align the right hinge and replace the two (M3x7, T8) and (M3x5, T8) epoxy screws to secure the right hinge to the display assembly.
Next steps
- Install the display bezel.
- Install the display assembly.
- Install the system board.
- Install the rear I/O board.
- Install the dock I/O board.
- Install the WWAN card.
- Install the WLAN card.
- Install the Wi-Fi I/O board.
- Install the heat-sink (UMA) or heat-sink (discrete).
- Install the fan.
- Install the base cover.
- Install the keyboard.
- Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
- Install the battery.
- Follow the procedure in after working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\