Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Latitude 5430 Rugged Service Manual

PDF

Installing the display bezel

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the display bezel and provides a visual representation of the installation procedure.

This image displays the installation of the display bezel

This image displays the installation of the display bezel screws

Steps

  1. Connect the touch cable to its connector on the touch screen board.
  2. Connect the eDP cable to its connector on the LCD module and flip the display bezel on the display assembly.
  3. Align the display bezel with the display assembly. Gently snap the display bezel into place.
  4. In sequential order, replace the 11 (M2.5x6, T8) blue screws that secure the display bezel to the display assembly.
    NOTE:Ensure that the display assembly is placed on a flat surface when replacing the screws to avoid light leakage from LCD. This must be done when part twisting assembly screw torque: 3 kgf-cm.
  5. Replace the 4 (M2.5x6, T8)yellow epoxy screws to secure the display bezel to the display assembly.

Next steps

  1. Install the display assembly.
  2. Install the system board.
  3. Install the heat-sink (UMA) or heat-sink (discrete).
  4. Install the fan.
  5. Install the rear I/O board.
  6. Install the dock I/O board.
  7. Install the WWAN card.
  8. Install the WLAN card.
  9. Install the Wi-Fi I/O board.
  10. Install the base cover.
  11. Install the keyboard.
  12. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
  13. Install the battery.
  14. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\