- Notes, cautions, and warnings
- Working on your computer
- Disassembly and reassembly
- Recommended tools
- Screw List
- SIM cover
- Base cover
- Battery
- WLAN card
- WWAN card
- Memory modules
- Solid-state drive
- Inner frame
- Hard disk drive
- Heatsink assembly—UMA
- Heatsink assembly-discrete
- DC-in port
- Coin-cell battery
- SmartCard reader
- Touchpad buttons
- Speakers
- LED board
- Keyboard
- Power button
- Hinge caps
- Display back cover assembly
- Display hinges
- Display (eDP) cable
- Display panel
- Display bezel
- Camera
- Palmrest assembly
- System setup
- Troubleshooting
- Getting help
Dell Latitude 5411 Service Manual
Removing the display assembly
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
- Remove the battery.
- Remove the WLAN card.
- Remove the WWAN card.
About this task
The figure indicates the location of the display assembly and provides a visual representation of the removal procedure.
Steps
- Remove the two (M2x3) screws that secure the EDP metal bracket to the computer.
- Peel the tape that secures the display cable to the system board.
- Open the latch and disconnect the display cable from the system board.
- Disconnect the touchscreen cable from the connector on the system board.
- Unroute the WLAN and WWAN cables from the retention clips.
- Remove the four (M2.5x5) screws that secure the display hinges to the chassis of your computer.
- Open the display hinges at an angle of 90 degrees and slightly open the display.
- Remove the palm-rest and keyboard assembly off the display assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\