- Notes, cautions, and warnings
- Working on your computer
- Disassembly and reassembly
- Recommended tools
- Screw List
- SIM cover
- Base cover
- Battery
- WLAN card
- WWAN card
- Memory modules
- Solid-state drive
- Inner frame
- Hard disk drive
- Heatsink assembly—UMA
- Heatsink assembly-discrete
- DC-in port
- Coin-cell battery
- SmartCard reader
- Touchpad buttons
- Speakers
- LED board
- Keyboard
- Power button
- Hinge caps
- Display back cover assembly
- Display hinges
- Display (eDP) cable
- Display panel
- Display bezel
- Camera
- Palmrest assembly
- System setup
- Troubleshooting
- Getting help
Dell Latitude 5411 Service Manual
Installing the smartcard reader board
Prerequisites
About this task
The figure indicates the location of the smartcard reader board and provides a visual representation of the installation procedure.
Steps
- Locate the smartcard reader board slot on your computer.
- Align and place the smartcard reader board into the slot on your computer.
- Replace the three (M2x3) screws that secure the smartcard reader board to the computer.
- Adhere the smartcard reader cable to the palmrest and connect the cable to the connector on the system board.
- Connect the touchpad button board cable to the connector on the system board.
Next steps
- Install the inner frame.
- Install the WLAN card.
- Install the WWAN card.
- Install the 2280 SATA SSD.
- Install the battery.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\