- Notes, cautions, and warnings
- Working on your computer
- Disassembly and reassembly
- Recommended tools
- Screw List
- SIM cover
- Base cover
- Battery
- WLAN card
- WWAN card
- Memory modules
- Solid-state drive
- Inner frame
- Hard disk drive
- Heatsink assembly—UMA
- Heatsink assembly-discrete
- DC-in port
- Coin-cell battery
- SmartCard reader
- Touchpad buttons
- Speakers
- LED board
- Keyboard
- Power button
- Hinge caps
- Display back cover assembly
- Display hinges
- Display (eDP) cable
- Display panel
- Display bezel
- Camera
- Palmrest assembly
- System setup
- Troubleshooting
- Getting help
Dell Latitude 5411 Service Manual
Installing the display panel
Prerequisites
About this task
The figure indicates the location of the display panel and provides a visual representation of the installation procedure.
Steps
- Connect the display cable to the connector and close the latch.
- Adhere the adhesive strip to secure the display cable connector.
- Turn back and place the display panel over the display back cover.
- Replace the two (M2.5x3) screws that secure the display panel to the display assembly.
Next steps
- Install the display hinge caps.
- Install the display bezel.
- Install the display assembly.
- Install the battery.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\