- Notes, cautions, and warnings
- Major components of your system
- Working on your computer
- Removing and installing components
- Recommended tools
- Screw List
- Disassembly and reassembly
- MicroSD card
- Base cover
- Battery
- WLAN card
- WWAN card
- Coin-cell battery
- Memory modules
- DC-in port
- Solid-state drive
- Solid state drive bracket
- Inner frame
- Touchpad buttons
- LED board
- Speakers
- Heatsink assembly
- System fan
- System board
- Keyboard assembly
- Keyboard bracket
- Power button
- Display assembly
- Display bezel
- Display panel
- Camera
- Hinge caps
- Display hinges
- Display (eDP) cable
- Display back cover
- Palmrest assembly
- Troubleshooting
- Getting help and contacting Dell
Dell Latitude 5400 Chromebook Service Manual
Installing the display assembly
About this task
NOTE Ensure that the hinges are opened to the maximum before replacing the display assembly on the palmrest and keyboard assembly.
Steps
- Align and place the system chassis under the hinges of the display assembly [1].
- Replace the four (M2.5x3) screws that secures the display assembly to the system chassis [2].
- Seat the system chassis on the display assembly.
- Connect the cable to the connector on the system board and adhere the adhesive tape [1].
- Reroute the eDP cable and connect it to the eDP connector [2].
- Place the eDP cable bracket on the system board [3].
- Replace the two (M2x4) screws that secures the eDP cable bracket to the system board [4].
Next steps
- Install the battery.
- Install the base cover.
- Install the microSD card.
- Follow the procedure in After working on your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\