- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Latitude 7320 Detachable
- Subscriber Identity Module (SIM) card
- Display assembly
- Solid-state drive
- WWAN card
- Speakers
- Rear Camera
- Microphone module
- Front Camera
- Kick stand
- Kickstand Hinges
- Docking connector
- Hall sensor daughter board
- Heat sink
- System fan
- Volume button daughter board
- Power-button and fingerprint reader
- Fingerprint reader
- Battery
- System board
- Smart card reader
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
Latitude 7320 Detachable Service Manual
Installing the volume button daughter board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the volume button daughter board and provides a visual representation of the installation procedure.
Steps
- Align and place the volume button daughter board on the system board.
NOTE:When installing the volume button daughter board, fully insert the power button module into its compartment, and then press the volume buttons to check whether the daughter board is correctly installed.
- Replace the two (M1.6x3) screws that secure the volume daughter board to the system board.
- Connect the volume daughter board FPC to the connector on the system board and close the latch.
Next steps
- Install the left system fan.
- Install the WWAN card.
- Install the display assembly.
- Install the SIM tray.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\