- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Latitude 7320 Detachable
- Subscriber Identity Module (SIM) card
- Display assembly
- Solid-state drive
- WWAN card
- Speakers
- Rear Camera
- Microphone module
- Front Camera
- Kick stand
- Kickstand Hinges
- Docking connector
- Hall sensor daughter board
- Heat sink
- System fan
- Volume button daughter board
- Power-button and fingerprint reader
- Fingerprint reader
- Battery
- System board
- Smart card reader
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
Latitude 7320 Detachable Service Manual
Installing the kick stand
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the kick stand and provide a visual representation of the installation procedure.
Steps
- Align the screw holes on the kick stand with the screw holes on the frame, and flip the system.
NOTE: Ensure that the pins on the kick stand are inserted into the alignment holes on the kick stand hinges.
- Replace the four (M1.6x3) screws that secure the kick stand to the kick stand hinges.
Next steps
- Install the display assembly.
- Install the SIM tray.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\