- Notes, cautions, and warnings
- Working on your computer
- Removing and installing components
- Software
- BIOS setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 7320/Latitude 7320 2-in-1 Service Manual
Removing the display assembly
Prerequisites
- Follow the procedure in before working inside your computer.
- Remove the microSD card.
- Remove the base cover.
- Remove the WWAN card.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Steps
- Remove the two (M2x2) securing the display cable bracket to the system board.
- Lift to remove the display cable bracket from the computer.
- Disconnect the display, camera, touch screen, sensor board cables from the system board and release them from cable guiding tabs.
- Open the display lid to 90º angle and remove the four (M2.5x5) screws securing the hinges to the palmrest assembly.
- Remove the display assembly from the computer.
NOTE:NOTE: The display assembly is a Hinge-Up Design (HUD) assembly and cannot be further disassembled once it is removed from the bottom chassis. If any components in the display assembly are malfunctioning and must be replaced, replace the entire display assembly.
Figure 1. Display assembly with antennae cables 
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\