- Notes, cautions, and warnings
- Working on your computer
- Removing and installing components
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Recovering the operating system
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- System diagnostic lights
- Updating the BIOS using the USB drive in Windows
- Updating the BIOS in Windows
- Backup media and recovery options
- WiFi power cycle
- LCD Built-in Self Test (BIST)
- BIOS recovery
- M-BIST
- RTC reset and Flea power release
- Getting help and contacting Dell
Latitude 7310 Service Manual
Installing the WLAN antenna bracket
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the WLAN antenna bracket and provide a visual representation of the installation procedure.
Steps
- Connect the antenna cable to the WLAN module on the system board.
NOTE:The antenna cable connectors are fragile and utmost care should be taken while replacing them.
Table 1. Antenna cable guideAntenna cable guide Cable color Connector White cable (Main) White triangle (△) on the WLAN module of the system board Black cable (Aux) Solid triangle (▲) on the WLAN module of the system board - Align and replace the WLAN antenna bracket on top of the antenna connectors.
- Replace the single M2x2.5 screws securing the WLAN antenna bracket to the system board.
Next steps
If you are replacing a component, remove the existing component before performing the installation procedure.
- Connect the battery cable
- Install the:
- RTC reset cycle
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\