- Notes, cautions, and warnings
- Working on your computer
- Removing and installing components
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Recovering the operating system
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- System diagnostic lights
- Updating the BIOS using the USB drive in Windows
- Updating the BIOS in Windows
- Backup media and recovery options
- WiFi power cycle
- LCD Built-in Self Test (BIST)
- BIOS recovery
- M-BIST
- RTC reset and Flea power release
- Getting help and contacting Dell
Latitude 7310 Service Manual
Removing the display assembly
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the:
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Steps
- CAUTION:If the system unit is shipped with WWAN card, remove the WWAN bracket and disconnect the antennae cables.Remove the two M2x2 screws that secures the eDP bracket to the system board and remove it from the system board.
- Disconnect the eDP cable, touch cable and camera cable from the system board.
NOTE:The display cable and sensor daughter board cable are bundled together with tape. Disconnect the sensor daughter board cable first followed by the display cable. To disconnect the display cable, pull the pull tab vertically.
- Remove the two M2.5x4 from both left and right hinges.
- Fold the LCD at an convenient angle to detach it from the palmrest assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\