Latitude 7310 Service Manual

Installing the system board

1. Align and replace the system board into the palmrest assembly.
2. Replace the single M2x2.5 screw securing the system board to the palmrest assembly.
3. Replace the USB Type-C bracket on the system board and secure it using the three M2x5 screws.
4. Connect the following cables:
   • IR camera cable (for systems shipped with IR camera)
   • Touchscreen cable (for systems shipped with touchscreen)
   • Display cable
   • Sensor daughterboard cable
   • Touchpad FFC
   • Battery LED FPC
   • USH daughterboard FFC
5. Replace the eDP bracket on the display cable connector of the system board and replace the two M2x2 screws securing it to the system board.
6. Re-route the antennae cable on the system board.
7. Replace the four M2x3.5 screws securing the F-beam FPC to the I/O board.