- Notes, cautions, and warnings
- Working on your computer
- Removing and installing components
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Recovering the operating system
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- System diagnostic lights
- Updating the BIOS using the USB drive in Windows
- Updating the BIOS in Windows
- Backup media and recovery options
- WiFi power cycle
- LCD Built-in Self Test (BIST)
- BIOS recovery
- M-BIST
- RTC reset and Flea power release
- Getting help and contacting Dell
Latitude 7310 Service Manual
Installing the I/O board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the I/O board and provide a visual representation of the installation procedure.
Steps
- Align the screw hole with that on the palmrest assembly and replace the I/O daughterboard into its slot on the palmrest assembly.
- Connect the F-beam FPC connector to the I/O board and secure it using the two M2x3.5 screws.
- Connect the power button cable to the I/O daughterboard.
- Replace the two M2x2.5 screws securing the power button to the I/O board.
NOTE:System configurations ordered with finger print reader there are two screws securing the finger print reader bracket to the palmrest assembly.
Next steps
- Install the:
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\