- Notes, cautions, and warnings
- Views of Latitude 5340/Latitude 5340 2-in-1
- Set up your Latitude 5340/Latitude 5340 2-in-1
- Specifications of Latitude 5340/Latitude 5340 2-in-1
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports and slots
- Internal slots
- Wireless module
- WWAN module
- Audio
- Storage
- Keyboard
- Keyboard function keys
- Camera
- Touchpad
- Power adapter
- Battery
- Display
- Fingerprint reader (optional)
- Sensor
- GPU—Integrated
- Hardware security
- Smart-card reader
- Operating and storage environment
- Dell support policy
- ComfortView Plus
- Using the privacy shutter
- Dell Optimizer
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locating the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Latitude 5340/Latitude 5340 2-in-1 Owner's Manual
Removing the display assembly (laptop)
Prerequisites
CAUTION:The information in this section is intended for authorized service technicians only.
- Follow the procedure in Before working inside your computer.
- Remove the base cover.
- Remove the battery.
- Remove the WWAN 4G card or WWAN 5G card.
- Remove the WLAN card.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Steps
- Remove the screw (M2x4) that secures the eDP bracket to the system board.
- Peel the adhesive tape that covers the eDP cable.
- Disconnect the eDP cable from the system board.
- Note the WLAN-antenna cable routing, and remove the WLAN-antenna cables from the routing guide on the fan.
- Disconnect the sensor cable from the system board.
- Remove the four screws (M2.5x4) that secure the left-display hinge and right-display hinge to the system board.
- Open the palm-rest assembly at an angle.
- Gently lift the display assembly off the palm-rest assembly.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\