Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Latitude 3340/Latitude 3340 2-in-1 Service Manual

Installing the touchpad

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the touchpad and provide a visual representation of the installation procedure.

Image of installing the touchpad moduleImage of installing the touchpad module

Steps

  1. Align and place the touchpad module into the slot on the palm-rest and keyboard assembly.
  2. Align the screw holes on the touchpad module to the screw holes on the palm-rest and keyboard assembly.
  3. Replace the six screws (M2x2) to secure the touchpad module to the palm-rest and keyboard assembly.
  4. Adhere the adhesive shielding cover over the touchpad.
  5. Connect the keyboard backlight-cable to the connector on the touchpad module. .
  6. Connect the keyboard-cable to the connector on the touchpad module close the latch.
  7. Connect the touchpad cable to the connector on the system board and close the latch.

Next steps

  1. Install the battery.
  2. Install the base cover.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\