Latitude 3340/Latitude 3340 2-in-1 Service Manual

Installing the display assembly

About this task

NOTE:The display assembly installation procedure is the same for both clamshell and 2-in-1 convertible chassis.

NOTE:Ensure that the hinges are opened to the maximum before replacing the display assembly on the palm-rest and keyboard assembly.

The following images indicate the location of the display assembly and provide a visual representation of the installation procedure.

1. Place the display assembly on a flat surface.
2. Slide the display assembly at an angle and place the system chassis under the hinges of the display assembly.
3. Gently press down on the display hinges to align the screw holes on the display hinges with the screw holes on the palm-rest and keyboard assembly.
4. Replace the four screws (M2.5x4) to secure the display hinges to the palm-rest and keyboard assembly.
5. Connect the display cable to its connector on the system board.
6. Align and place the display-cable bracket on the display-cable connector on the system board.
7. Replace the two screws (M2.5x4) to secure the display-cable bracket to the system board.