Dell Latitude 3300 Service Manual

Installing the display assembly

1. Install the display assembly aligning the hinge caps on the palmrest.
   
2. Align the hinges to the screw holes on the system board [1] and tighten the five M2.5x5.0 screws [2] to secure the display assembly to the computer.
   
3. Route the antennae cable along the edges of the fan case [1] and stick a piece of tape [2] to secure it to the system board.
4. Connect the EDP cable [3], place the EDP bracket on the connector [4] , and secure it to system board using the single screw [5].
   
5. Install the:
   1. DC-in cable
   2. WLAN card
   3. battery
   4. base cover
   5. microSD card
6. Follow the procedure in After working inside your computer.