Dell Latitude 3300 Service Manual

Installing the touchpad

1. Install the touchpad FFC cable into its slot on the touchpad module [1] and close the actuator [2] to secure it.
   
2. Place the touchpad into the slots on the computer [1] and tighten the three M2.0x3.0 screws [2] to secure the touchpad to the system.
   
3. Secure the touchpad using a piece of tape.
   
4. Affix the bottom bracket [1] that secures the touchpad to the computer.
5. Install the three M2.0x3.0 screws [2] securing the touchpad to the system.
   
6. Affix the tapes [1,2,3] on the touchpad and connect the touchpad cable [4] to the connector on the system board.
   
7. Install the:
   1. battery
   2. base cover
   3. microSD card
8. Follow the procedure in After working inside your computer.