Install the battery cable on the battery [1] and secure it using a piece of tape [2].
NOTE This procedure illustrates a 3-cell 42 WHr battery, a 4-cell 56 WHr battery mounts is slightly bigger in size and attaches to different mount points on the palmrest.
Insert the battery into the slot on the computer [1] and align the battery and the screw hole on the palmrest [2].
Install the battery [3] and the single M2.0x3.0 screw to retain the battery [4] to the palmrest.
Install the battery support bracket [1] and install the two M2.0x3.0 screws securing the battery to the palmrest [2].
Connect the battery cable to the system board [1] and secure it using a piece of tape [2].
Route the battery cable along the memory module bracket and secure it using a piece of tape [3].