Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Latitude 7220EX Rugged Extreme Tablet Service Manual

Installing the rear camera

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the rear camera and provides a visual representation of the installation procedure.

Image: Installing the rear camera

Steps

  1. Align the screw holes on the rear camera circuit board with the screw holes on the tablet chassis.
  2. Replace copper adhesive tape and the three (M2x5) screws to secure the rear camera circuit board to the chassis.

Next steps

  1. Install the system board.
  2. Install the coin-cell battery.
  3. Install the front camera.
  4. Install the microphone.
  5. Install the WWAN.
  6. Install the WLAN.
  7. Install the solid-state drive.
  8. Install the system fan.
  9. Install the SSD heat-sink.
  10. Install the display assembly.
  11. Install the batteries.
  12. Install the system cover.
  13. Install the battery cover assembly.
  14. Follow the procedure in after working inside the tablet.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\