- Notes, cautions, and warnings
- Working on your tablet
- Major components of the tablet
- Field service information
- Safety instructions
- Recommended tools
- Screw list
- Customer Replaceable Units (CRU) and Field Replaceable Units (FRU) list
- Disassembly and reassembly
- System setup
- Software
- Troubleshooting
- Getting help and contacting Dell
Latitude 7220EX Rugged Extreme Tablet Service Manual
Installing the front camera
Prerequisites
About this task
The figure indicates the location of the front camera and provides a visual representation of the installation procedure.
Steps
- Align the front camera circuit board over the camera slot.
NOTE Opposite side of the camera circuit board is placed to connect cable in the connector.
- Connect the front camera cable and plug in the cable to the connector.
- Flip the front camera circuit board.
- Align front camera circuit board with screw hole.
- Place the camera lens case to the camera placeholder.
- Replace the screw (M2x3) to secure the front camera circuit board on the tablet chassis.
- Slide the lens shutter in the lens channel and push towards left.
- Replace the adhesive tape on the camera assembly and system board shield.
Next steps
- Install the display assembly.
- Install the stylus.
- Install the batteries.
- Install the system cover.
- Install the battery cover assembly.
- Follow the procedure in after working inside the tablet.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\