Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Latitude 7220EX Rugged Extreme Tablet Service Manual

PDF

Installing the system fan

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the location of the system fan and provides a visual representation of the installation procedure.

Image: Installing the system fan

Steps

  1. Align the screws on the system fan with the screw holes on the system board.
  2. Replace the four (M2x5) screws to secure the system fan to the chassis.
  3. Connect the system fan cable to the connector on the system board.
  4. Route the system fan cable through the routing guide on the system fan.

Next steps

  1. Install the SSD heat-sink.
  2. Install the display assembly.
  3. Install the stylus.
  4. Install the batteries.
  5. Install the system cover.
  6. Install the battery cover assembly.
  7. Follow the procedure in after working inside the tablet.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\