Latitude 12 Rugged Extreme Tablet – 7212 Owner's Manual

Installing docking board

1. Connect the docking board cable to the connector.
   NOTE:Slide the cable through the connector clips and release the latch.
2. Align the docking board with the screw holes on the tablet chassis.
3. Replace the screws (4) to secure the back docking board to the tablet chassis.
4. Ensure to replace the adhesive tape to secure the docking board to the system chassis.
   CAUTION:Connect the cables to respective slot that were disconnected while removing the docking board. See removing system board.
5. Install the:
   1. System board
   2. WWAN
   3. WLAN
   4. System fan
   5. Heat sink
   6. Display assembly
   7. Battery
6. Follow the procedure in After working inside your computer.