Latitude 12 Rugged Extreme Tablet – 7212 Owner's Manual

Installing bottom base assembly

1. Connect the back camera cable to the connector.
2. Align the back camera circuit board with the screw holes on the tablet chassis.
3. Replace the screws (3) to secure the back camera circuit board to the tablet chassis.
4. Connect the finger print reader cable on the system board.
   CAUTION:Connect the cables to respective slot that were disconnected while removing the back camera circuit board. See removing system board.
5. Install the:
   1. System board
   2. WWAN
   3. WLAN
   4. System fan
   5. Heat sink
   6. Display assembly
   7. Battery
6. Follow the procedure in After working inside your computer.