- Notes, cautions, and warnings
- Working on your computer
- Removing and installing components
- Recommended tools
- Screw size list
- Battery
- Installing the battery when the cross strap is attached - Optional
- Subscriber Identification Module (SIM) card
- Display assembly
- Stylus
- WLAN card
- WWAN card
- CMOS battery
- Power button assembly
- Micro serial port and power connector port
- Front camera
- Microphone
- Heat sink for SSD
- PCIe Solid State Drive (SSD)
- System fan
- System Board
- Docking Board
- Back Camera
- Smartcard holder
- Bottom base assembly
- Technology and components
- Software
- System specifications
- Product overview
- Power and battery-status light
- System specifications
- Processor specifications
- Memory specifications
- Storage specifications
- Audio specifications
- Video specifications
- Camera specifications
- Communication specifications
- Port and connector specifications
- Display specifications
- Touch specifications
- Adapter specifications
- Physical dimension specifications
- Environmental specifications
- System setup
- Boot Sequence
- Navigation keys
- System Setup overview
- General screen options
- System Configuration screen options
- Video screen options
- Security screen options
- Secure Boot
- Intel software Guard Extensions
- Performance screen options
- Power Management
- POST Behavior
- Manageability
- Virtualization Support options
- Wireless options
- Maintenance
- System Log
- Support Assist System Resolution
- Troubleshooting
- Ecosystem Accessories
Latitude 12 Rugged Extreme Tablet – 7212 Owner's Manual
Dell Enhanced Pre-Boot System Assessment - ePSA diagnostic 3.0
You can invoke the BIOS and ePSA diagnostics by either:
NOTE:As the rugged tablet is without keyboard, perform the following ePSA diagnostic.
- To enter BIOS (system setup) without keyboard, Power on system. Press on Volume decrease button during startup (as the Dell Logo appears) until the BIOS (system setup) screen is displayed.
- To enter ePSA (system setup) without keyboard, Power on system. Press on Volume increase button during startup (as the Dell Logo appears) until the BOOT Menu screen is displayed.NOTE:Use the Volume increase button to navigate to respective diagnostic and press on Volume decrease button to select the required option.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\