- Notes, cautions, and warnings
- Working on your computer
- Removing and installing components
- Technology and components
- System specifications
- Processor specifications
- System specifications
- Memory specifications
- Video specifications
- Audio specifications
- Port and connector specifications
- Communication specifications
- Camera specifications
- Display specifications
- AC adapter specifications
- Battery specifications
- Physical specifications
- Environmental specifications
- System setup
- Entering BIOS without keyboard
- System setup options
- General screen options
- System Configuration screen options
- System Configuration screen options
- Video screen options
- Security screen options
- Secure Boot
- Intel software Guard Extensions
- Performance screen options
- Power Management screen options
- POST Behavior
- Virtualization Support options
- Wireless screen options
- Maintenance
- System logs screen options
- System Log
- Updating the BIOS
- System and setup password
- Software
- Troubleshooting
- Contacting Dell
Latitude 5290 2-in-1 Owner's Manual
Installing the display assembly
- Place the display panel on a plane surface.
- Connect the display cable to the connector on the system board
- Connect the battery cable to the connector on the system board.
- Install the display panel on the tablet and press the edges until they snap in.
- Flip the tablet and open the kickstand.
- Replace the M1.6 x 3 screws to secure the tablet to the display panel.
- Install the:
- Follow the procedure in After working inside your tablet.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\