- Notes, cautions, and warnings
- Working on your computer
- Removing and installing components
- Screw size list
- Recommended tools
- Micro Secure Digital (SD) Card
- Subscriber Identity Module (SIM) Card
- Base cover
- Battery
- PCIe Solid State Drive (SSD)
- WLAN card
- WWAN card
- Power board
- Speaker
- Fingerprint Board
- LED Board
- Smart Card Cage
- Heat Sink
- Display Assembly
- Removing dummy SIM card tray
- System Board
- Real time clock (RTC)
- Keyboard
- Display Panel
- G-sensor board
- Camera
- Palmrest
- Technology and components
- System specifications
- System specifications
- Processor specifications
- Memory specifications
- Video specifications
- Display specifications
- Audio specifications
- Storage options
- Communication specifications
- Near field communication (NFC) specifications
- Fingerprint reader specifications
- Ports and connector specifications
- Touchpad specifications
- Camera specifications
- IR camera specifications
- Display specifications
- AC adapter specifications
- Battery specifications
- Physical specifications
- Environmental specifications
- System setup
- Boot menu
- Navigation keys
- System setup options
- General screen options
- System Configuration screen options
- Video screen options
- Security screen options
- Secure Boot screen options
- Intel software guard extensions screen options
- Performance screen options
- Power management screen options
- POST behavior screen options
- Manageability
- Virtualization support screen options
- Wireless screen options
- Maintenance screen options
- System logs screen options
- Updating the BIOS in Windows
- System and setup password
- Troubleshooting
- Contacting Dell
Latitude 5289 2-in-1 Owner's Manual
Removing the power board
- Follow the procedure in Before working inside your computer.
- Remove:
- MicroSD card
- SIM card trayNOTE: SIM Card tray is available only if your computer is shipped with a WWAN card.
- base cover
- battery
- To remove the power board:
- Peel the coin cell battery affixed to the computer [1].
- Disconnect the power cable from the system board [2].
- Remove the M2.0x3.0 screws to release the power board [3].
- Lift the power board from the computer [4].
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\