Latitude 5289 2-in-1 Owner's Manual

Removing the display assembly

1. Follow the procedure in Before working inside your computer.
2. Remove the:
   1. Micro SD
   2. base cover
   3. battery
   4. WLAN card
   5. WWAN card
3. Peel the tapes that secure the antenna cables and un route the cables from the routing clips.
   
4. Disconnect the :
   1. IR camera and touchscreen cable [1].
   2. Remove the M 2 x 1.7L screws that secure the eDP bracket and lift it away from the computer [2].
   3. Disconnect the eDP cable from the system board [3].
   4. Disconnect th G-sensor and eDP cables [4].
   
5. Lift the base of the computer away from the display assembly.
   
6. To remove the display assembly:
   1. Place the base of the computer with the display assembly at 270 degrees (laptop) or 90 degrees (tablet).
      NOTE: If the system is used as a laptop, then display assembly should be at 270 degrees and for a fully closed tablet configuration, the display should be at 90 degrees.
   2. Remove the M2.5 x 4.0 screws that secure the display hinge brackets [1].
   3. Lift the display assembly away from the computer [2].