- Notes, cautions, and warnings
- Introduction to this guide
- Planning an upgrade
- Completing pre-upgrade tasks
- Pre-upgrade process - Overview
- Collect cluster information
- Check cluster readiness
- Verify configurations and settings
- Download the OneFS installation bundle file
- Upgrade compatibility check utility
- On-Cluster Analysis tool
- HealthCheck tool
- Backup data
- Complete or stop jobs in progress
- Update Node Firmware Package
- Update Drive Support Package
- Configure IPMI ports
- Disable SupportAssist or Secure Remote Services (SRS)
- Performing the OneFS upgrade
- Upgrade process overview
- Completing a parallel upgrade of OneFS
- Completing a rolling upgrade of OneFS
- Completing a simultaneous upgrade of OneFS
- Adding a node to the cluster while an upgrade is in progress
- Committing an upgrade of OneFS
- Rolling back an upgrade of OneFS
- Verify the OneFS installation using the CLI
- Completing post-upgrade tasks
- Troubleshooting your upgrade
PowerScale OneFS Upgrade Planning and Process Guide
Rolling back an upgrade of OneFS
The upgrade rollback feature allows you to stop the upgrade that is in progress and restore all the upgraded nodes to the previous committed version of
OneFS.
NOTE:You can roll back an upgrade only if the upgrade process is still active and the upgrade has not been committed. A committed upgrade cannot be rolled back.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\